Step 2, Connect Electrical - GE ZVC36LSS Installation Instructions Manual

Installation Instructions
[STEP 2] CONNECT ELECTRICAL
Verifg that power is turned off at the source.
WARNING:
,f house wiring is not
2-wirewith a ground wire, an electrician will need
to convertexisting w iringto meet these specs.
When house wiringis aluminum, be sureto
use U.L approved anti-oxidant c ompound
and aluminum-to-copper connectors.
AVERTISSEMENT :
Si le cablage de la maison n'est pas un cablage
5 deux ills avec un fil de terre, un @lectricien
doit convertir votre cablage existant 5 ces
caract@istiques techniques. Si le cablage de votre
maison est en aluminium, assurez-vous d'utiliser
un compos@ anti-oxgdant approuv6 et des
raccords aluminium _ cuivre.
I. Place insert sleeve on padded, get stable, surface
below cutout (can use flattened carton to pad
surface).
2. Remove the junction box cover
00000
\
00000
\
4. Connect white leads to branch circuit white lead.
5. Connect blackleadsto branch circuit blacklead.
6. Connect green/yellow leads to branch circuit green
lead.
7. Secure all connections with wire nuts on each
electrical connector
00000
\
Cove
r
Screws
Wires
3. Pull house wires through wall of insert sleeve and
attach the strain relief. Thread the house wire
through the junction box.
8. Carefully push wires intojunction box and replace
cover
9. Secure junction box cover with original screws.
17