Abbreviated Dialing; Abbreviated Number - Toshiba ESTUDIO170F Operation Manual

Abbreviated Dialing

Once an Abbreviated Dial Num-
ber is programmed with a valid
remote facsimile location, that
location can be accessed by
recalling the corresponding Ab-
breviated Dial Number.
The document must be loaded
and the resolution and contrast
set before a transmission using
Abbreviated Dialing (see pages
83 and 84).
90
1
Press the SPEED
DIAL Key
Press:
SPEED DIAL
ALPHA
+
ABB. NUMBER
(1-999) [ ]
2
Enter the

Abbreviated Number

Enter the Abbreviated Dial
Number (1 to 999) assigned to
the desired party.
NOTES:
• When an incorrect num-
ber is entered, use
to delete preceding dig-
STOP
its, or press once
to start over from the be-
ginning.
• Any leading zero (0) can
be omitted from the Ab-
breviated Dial Number.
Example of Abbreviated Dial
Number, 10:
ABB. NUMBER
(1-999) [ 10]
3
Press the START Key Tray
When the correct number is
displayed, press:
START
The Abbreviated Dial Number
and the name of the party will
appear on the LCD display for
about 2 seconds.
Your facsimile will automatical-
ly start scanning the document
into memory (if enabled). While
scanning, the facsimile dials,
connects, and starts transmis-
sion.
ABB. NBR= 10
LONDON OFFICE
Displayed for 2 seconds
SCANNING DOC P001
FILE NBR = 091
During scan to memory
JAN-31 09:43 AM 99%
AUTO RECEIVE
During transmission
NOTE:
When the number entered
(within the range of 1
through 999) is not prepro-
grammed with a specific
party's facsimile or tele-
phone number, the mes-
sage "NUMBER NOT LIST-
ED" is displayed for 2 sec-
onds and then the facsimile
returns to the screen in
Step 1.
ABB. NBR= 10
NUMBER NOT LISTED
Displayed for 2 seconds