Task Summaries For Creating And Configuring Npartitions; Partition Default Attributes - HP Integrity Superdome 2 16-socket Administrator's Manual

Task summaries for creating and configuring nPartitions

Table 5 nPartition Boot and Reset Task Summaries
Task

Partition Default Attributes

Create new nPartition
Verifying the nPartitions using CLI
Verifying the nPartitions using GUI
Deleting an nPartition
Renaming an nPartition
Assigning blades and I/O bays to
an nPartition
Unassigning blades and I/O bays
from an nPartition
Setting blade attributes
nPartition health status
Partition default attributes
The pardefault command enables you to modify the current default values of certain generic
nPartition attributes or attributes specific to an OS type.
NOTE: The generic nPartition attributes are maintained independently for each supported OS
type to provide better configuration flexibility. This means that an OS type is always selected during
the creation of nPartition, with the default OS type being used if none is explicitly selected.
The following example shows the output of the pardefault command executed on a system
where the default values are not modified.
[Original Defaults]
Parcon Default OS Type
OS Type
Hyper Threading at activation
SLM Percentage
ILM granule size
SLM granule size
VGA
[Current Defaults]
Parcon Default OS Type
OS Type
Hyper Threading at activation
SLM Percentage
ILM granule size
SLM granule size
VGA
For more information, see help pardefault.
Summary
See (page 39).
See (page 40).
See (page 41)
See (page 42).
See (page 42).
See (page 43).
See (page 43).
See (page 45).
See (page 47).
See (page 75).
: HPUX_11iV3
: HPUX_11iV3
: Enabled
: 87.50%
: 1024 MB
: 1024 MB
: Enabled
: HPUX_11iV3
: HPUX_11iV3
: Enabled
: 87.50%
: 1024 MB
: 1024 MB
: Enabled
Task summaries for creating and configuring nPartitions 39