Washing The Dishes; Programme Data; Aqua Sensor; Zeolith Drying - Siemens SN66T094GB Operating Instructions Manual

en

Washing the dishes

Programme data

The programme data (consumption
values) can be found in the summary of
instructions. They refer to normal
conditions and the water hardness set
value : . Different influencing factors
such as e.g. water temperature or line
pressure may result in deviations.

Aqua sensor *

* depending on model
The Aqua sensor is an optical measuring
device (light barrier) which measures the
turbidity of the rinsing water.
The Aqua sensor is used according to the
programme. If the Aqua sensor is active,
"clean" rinsing water can be transferred to
the next rinse bath and water consumption
can be reduced by 3–6 litres. If the
turbidity is greater, the water is drained
and is replaced with fresh water. In the
automatic programmes the temperature
and running time can also be adjusted to
the degree of soiling.

Zeolith drying

The appliance features a Zeolith container
Zeolith is a mineral which can store
moisture and heat energy and release
them again.
During the washing step this heat energy
is used to dry the mineral and heat up the
rinsing water.
During the drying phase moisture from the
washing compartment is stored in the
mineral and heat energy is released. This
released heat energy is blown into the
washing compartment with dry air. This
accelerates and improves drying.
These processes therefore save a great
deal of energy.
16
ã=
Warnings
– Please ensure that the intake opening
1J is not obstructed and do not place
any temperature-sensitive utensils in
the lower basket at the rear right side
above the blow opening 1R.
– Do not touch the blow opening 1R.
The blow opening becomes hot and,
furthermore, any damage will result in
a chargeable callout by customer
service.

Switching on the appliance

– Turn on the tap fully.
– Open the door.
– Switch on ON/OFF switch (.
The display of the last selected
programme flashes. This programme
remains selected if no other
programme button 0 is pressed. The
expected programme duration flashes
on the digital display 8.
– Press the START button )".
– Close the door.
The programme starts running.
Optical display while the
programme is running *
* depending on model
While the programme is running, a light
spot shines on the floor under the
appliance door. Do not open the
dishwasher door until the light point is no
longer visible on the floor.
If the appliance is installed at eye-level,
with flush furniture front, the light point is
not visible.
This function can be changed as follows:
– Open the door.
– Switch on ON/OFF switch (.
– Hold down programme button # and
press START button )" until : .... is
indicated on the digital display.
– Release both buttons.
The LED for button # flashes and the
digital display 8 displays the factory
setting : .
– Press programme button # until the
factory set value :
the digital display 8.
is indicated on