Sample Configuration - NEC Express5800/320Ma User Manual

A sample configuration of the ftServer Software Availability Manager instances follows.

Sample Configuration

Table 4-1 describes the parameters and controls on the Express5800/320Ma
Monitored Instances tab. You use these to configure the ftServer Software Availability
Manager instances. These are described in greater detail in
page 2-2.
Table 4-1. SAM Parameters
Parameter
Select Instance
Enable alerts for
selected instance
Scan poll rate (in
seconds)
Email Alert ID
Program to launch
(optional)
Scan Retry
Number of scan retries
Description
The window in which the SAM instances appear.
Enables warnings and alarms to be generated when
the monitored component highlighted in the Select
Instance menu exceeds its thresholds.
The interval, in seconds, at which SAM will scan
(poll) an instance to detect a possible threshold
violation.
The name of the alert to be sent. This is either a
user-defined alert or the Default alert.
The program, if any, that you want to run in the event
of a threshold violation. The program must not
interface with (or need a response from) the user, as
no window will be displayed. Also, the program must
exit by itself.
This field is blank by default.
A check box that enables you to use Number of
scan retries and Scan retry poll rate (in seconds).
The number of times to retry the scan at the Scan
retry poll rate (in seconds) interval.
Sample Configuration
"Instance Parameters" on
Sample Configuration
Chapter 4
4-
4-1