Accessories; Antenna Connection; Headphone Jack - Sharp 14D2-SS Operation Manual

Accessories

After unpacking, check to make sure that the following accessories are included:
TV/VIDEO
1 2 3
4 5 6
7 8 9
0
CH
CH
FUNCTION TIMER PICTURE
SYSTEM NORMAL
TV
Remote control

Antenna Connection

• The following is a brief explanation of the types of connection that are used for coaxial cables:
(1) If your outdoor antenna uses a 75-ohm coaxial cable, then
the connection to the TV is via DIN45325 plug (shown at
right). Plug this into the antenna jack at the rear of the TV
set.
(2) If your outdoor antenna uses a 300-ohm twin-lead flat
feeder, change this for a 300-ohm to 75-ohm impedance
converter and plug it into the antenna jack at the rear of the
TV set.
• Rod Antenna Connection
Antenna
mounting socket
AV-IN OUT
Antenna jack
• Remove the power cord from the electrical outlet before connecting the antenna to the rear of the TV set.
• If you are using a rod antenna and the signal from TV station is weak or not clear, the picture may not display clearly
or properly. In this case, we recommend that you use an outdoor antenna.

Headphone Jack

• Select an appropriate volume so as not to injure your hearing.
• To avoid injure your hearing, do not put on the headphone on your ear before plug in the headphone to the headphone
jack and before the power is turn on.
• Take out the headphone from your ear before unplug the headphone from headphone jack and before the power is turn off.
• The proper impedance for the headphone is 32 ohms.
• Remove the headphone plug from the jack when not using the headphone.
‰
3
Size-AA dry batteries
Rod Antenna
Feeder
Impedance
Converter
AUDIO
VIDEO
(14D2-SS)
Insert headphone plug into headphone jack to listen to audio with
headphone.
• The audio from the speakers is turned off.
300 - 75 impedance converter
75-ohm coaxial cable (round cable)
300-ohm twin-lead feeder
(1) Insert the rod antenna's base post into the
antenna mounting socket until it clicks into
position.
(2) Connect the feeder to the impedance converter.
(3) Plug the impedance converter into the antenna
jack at the rear of the set.
• Rod antenna and impedance converter are only
included in model 14D2-SS.
Rod antenna (dipole)
with ribbon feeder
(Only for 14D2-SS)