Programming The Remote Control; Programming Other Equipment; Auto Backlight; Backlight Time Out - Sony BRAVIA KDL-40Z4100 Operating Instructions Manual

Programming the Remote
Control
Tile remote control can be programmed to operate
other equipment and is pre-programmed to operate
the following Sony equipment.
DVD DVD Player 31033
AMP Receiver 52172
STB Digital Satellite 01639
• Any of the FUNCTION buttons can be programmed to
operate other equipment regardless of the labeling. For
example, DVD can be programmed to operate a Blu-
ray player.
Confirm the Programming
If you can turn your equiplnent on and off using
the green POWER button, the programming is
complete. If not, try the next code listed.
• In some cases, you may not be able to program your
remote control. If this is the case, use your equipment's
own renlote control.
Follow the steps below to program your TV
remote control.
1 Find the code that corresponds to your
equipment from page 27. If more than one
code is provided, try programming the first
code listed.
Press and hold DVD, AMP or STB
simultaneously with the INPUT button and
release. When in the programming mode, the
FUNCTION button blinks for approximately
30 seconds until a code is entered.
3
Enter the five digit code using 0-9. while the
FUNCTION button is lit. If the code is not
entered within 30 seconds, you must repeat
step 2.
4 Press @ or ENT to confirm the code. If
successfully programmed, the FUNCTION
button blinks twice; if not, it blinks five times.
26
The backlight can be set to light up when a button
is pressed.
To set backlight:
Press LIGHT and MUTING sinmltaneously until
the four FUNCTION buttons blink red.
To turn off backlight:
Press LIGHT and MUTING until the TV button
blinks red.
The remote control can be set to remain lit longer
than the default time setting of approximately five
seconds with the FUNCTION buttons.
To change backlight time setting:
1
Press LIGHT, VOL+, andthen CH+
simultaneously until the FUNCTION button
blinks red.
2 Select the FUNCTION button that conesponds
to your preferred time out setting and press
®.
DVD 5 seconds (default) AMP 10 seconds
STB 15 seconds "IV 20 seconds
To reset the remote control to the factory default
settings, press SOUND, TV POWER, and then
@. The FUNCTION buttons blink red
simultaneously when successfully reset.