Install Additional Mass Storage Devices - HP D7171A - NetServer - LPr Installation

Install Additional Mass Storage Devices

6
NOTE If you are installing an IDE drive or SCSI devices with certain
configurations, you will need additional cables or adapters.
For configuration information, see the Technical Information
Label on the side of the chassis or Information Assistant on
the HP Navigator CD-ROM.
For part numbers for HP cables, adapters, and trays, see the
technical information labels on the top and side of chassis.
Shelf 3
A SCSI, IDE or flexible disk drive can be installed in
Shelf 3.
If you are installing a narrow (50-pin) SCSI device, it can
be cabled with the CD-ROM in Shelf 2.
If you are installing a SCSI device, set the jumpers on the
device to an unused address (the CD-ROM drive is set to
SCSI address 5.) Do not terminate device if using
NetServer cable.
All devices must be installed in mass storage trays.
Hot Swap Subsystem
All devices must be installed in mass storage trays.
Unlock the hot swap subsystem using the same key used
to unlock the NetServer cover. The key is located in the
keybag attached to the rear of the HP NetServer.
Cabling configuration diagrams of the hot swap
subsystem are shown on the Technical Information Label
on the side of the chassis and in Information Assistant.
SCSI address setting information is in Information
Assistant and the HP NetServer LH
7
(Optional) Install Redundant Power Supply
Install the redundant power supply by following the instructions
included with the power supply.
CAUTION To ensure proper cooling either two power supplies
or one power supply and one fan must be installed at
all times.
8
Configure the HP NetServer and
Install Additional ISA Boards
NOTE Do not install ISA boards until instructed
by the Configuration Assistant program.
1. Reassemble the HP NetServer and connect the power cord.
2. Turn on the HP NetServer and monitor.
3. If the HP NetServer Navigator CD-ROM is not loaded in the
CD-ROM drive, insert the CD-ROM into the CD-ROM drive now
and press the Reset button on the front of the server. The HP
NetServer automatically boots from the HP NetServer
Navigator CD-ROM.
If an error message appears, ignore it and press the F1 key. If
an error message appears in Configuration Assistant, press
F10 to continue.
4. Go to the HP NetServer Navigator Main Menu and select
"Configuration Assistant."
Pro User Guide .
5. Recommended: If you have installed all accessories except the
ISA boards, go to the Express Configuration Menu. Follow the
instructions on the screen to configure your HP NetServer.
You are finished with the Installation Road Map. Follow the
instructions in Configuration Assistant to continue your
NetServer installation.
NOTE If you are installing one accessory at a time, go to
the Custom Configuration Menu and select the
Help button. Follow the instructions on the screen
to configure your HP NetServer. Repeat
configuration process for each accessory.
Technical
Information
Label (on top
of chassis)
Shelf 3
(No tray
provided)
Key Lock
Technical
Information
Label with
cabling
configuration
information