Installing The Bezel Hinge And Latch Plate; Installing The Lh 3R In The Rack; For Hp Racks; For Non-Hp (Compaq) Racks - HP D7171A - NetServer - LPr Manual

Chapter 3

Installing the LH 3r in the Rack

Refer to the documentation listed below to install the LH 3r in the rack.

For HP Racks

Refer to the HP NetServer LH 3/LH 3r User Guide. For cabling instructions,
refer to the documentation that came with the rack, and to the Rack Cabling
Reference for the HP NetServer LH 3r.
For Non-HP ( Compaq) Racks
Refer to the HP NetServer LH 3r Non-HP Rack Installation Guide. For cabling
instructions, refer to the documentation that came with the rack, and to the Rack
Cabling Reference for the HP NetServer LH 3r.
Installing the Bezel Hinge and Latch Assembly
Install the bezel hinge and latch assembly, referring to Figure 3-5:
The bezel hinge is a long plastic part with five screw holes, two on the left and
three on the right.
1. Position the bezel hinge so that the three screw holes in the plastic tabs
are aligned with the screw holes in the NetServer chassis, then attach the
bezel hinge to the NetServer with the supplied screws. The other two
screw holes on the left are used to attach the NetServer to the rack after it
has been fastened to the rack rails and installed in the rack.
The latch plate is a small metal part with four screw holes, two on the left and
two on the right, and a black plastic latch mounted on it. When it is installed
and the bezel is attached to the NetServer, this latch engages the bezel and holds
it in place.
1. Position the latch plate so that the two screw holes on the left are aligned
with the screw holes in the NetServer chassis, then attach the latch plate
to the NetServer with the supplied screws. The other two screw holes on
the right are used to attach the NetServer to the rack after it has been
fastened to the rack rails and installed in the rack.
18
Installing LH 3r Components