HP D7171A - NetServer - LPr User Manual page 19

Chapter 1
5. As the left P LED turns green, observe the right A LED and the board
status while you wait a few seconds for the software driver to initialize the
PCI board. See Figure 13.
The left P (Power) LED should be green at this point.
Figure 13. PCI Hot Plug Utility –Power Turned On
6. If the right A (Attention) LED stays red in the Hot Plug Utility window
and the rear panel Attention LED stays Amber, then consider these steps:
a. Ensure all the required cables are attached to the adapter.
b. Power down the slot as described in Steps 2 to 5 of the section
"Powering Down the PCI Slot" and then re-seat the PCI board.
c. Ensure an identical PCI board was used as a replacement.
d. Write down the part number and revision level of the PCI board and
then contact the manufacturer to determine if a new software driver is
required.
If necessary, install a new driver and repeat this procedure. See the
Help file for more information.
7. Observe the two LEDs for this slot on the rear panel.
PCI Hot Plug Utility for Microsoft Windows NT
15