Removing The Terminator Board - HP D5970A - NetServer - LCII Installation Manual

Chapter 4
If any accessory boards block access to the processors (or VRM positions in the
HP NetServer LPr), refer to your NetServer documentation to remove those
accessory boards.

Removing the Terminator Board

If your system has one processor, a terminator board is installed in the secondary
processor position. You must remove the terminator board before installing a
processor module into this slot. (See Figure 4-3).
1. Remove the terminator board from the secondary processor position as
shown in Figure 4-3. Hold the terminator board by its edges, and gently
pull it directly upwards.
Terminator
Board
Figure 4-3. Removing the Terminator Board
2. Save the terminator board for future use.
40
Installation in E 60 and LPr