2.
Gently push the subpanel out the back of the front bezel (1).
Figure 5-12
3.
Remove the desired bezel blank by applying outward pressure on the subpanel (1) and pulling the
blank away (2).
NOTE:
The bezel blanks are keyed to assist you in replacing them. Also, the subpanel can be rotated
90 degrees to install optical drives in a desktop orientation.
Front panel I/O device assembly
This section describes how to remove and install a front panel I/O device assembly.
Removing the front panel I/O device assembly
To remove the front panel I/O device assembly:
1.
Disconnect power from the system
access panel
(Removing the front bezel on page
2.
If necessary, unlatch the plastic snap that secures the cables inside the chassis (1), and then
disconnect the front panel I/O device assembly cables from the system board (2).
Figure 5-13
66
Chapter 5 Removal and replacement procedures
Removing the bezel blanks
(Predisassembly procedures on page
(Removing the side access panel on page
65).
Removing front panel I/O device cables
57), remove the side
61), and then remove the front bezel
ENWW