Connecting The Audio Set Receiver - Epson MovieMate 30s Quick Manual

Connecting the Audio Set Receiver

Before you begin, make sure that your audio system is turned off. Then follow the
steps in these sections on:
■
"Attaching the Antenna" below
■
"Powering the Receiver" on page 14
■
"Connecting the Receiver's Audio Cable" on page 14
Attaching the Antenna
1. Remove the red cap from the receiver's antenna connector.
2. Attach one of the included antennas to the receiver, then hand-tighten the nut
at the base of the antenna.
Caution:
Do not use a tool to tighten the nut, or you may damage the receiver.
3. If necessary, rotate the antenna so that it is facing upwards.
When you're finished attaching the antenna, see "Powering the Receiver" on
page 14.
Connecting the Audio Set Receiver
13