Assembly Of Hopper Bag - Craftsman 24222 - 42 in. High Speed Sweeper Owner's Manual

ASSEMBLY OF HOPPER BAG
STEP 10- ASSEMBLE UPPER TUBES
, Fit the ends of the two upper hopper tubes into the
ends of a rear hopper tube. Align the holes in the ends
of the tubes and insert plastic plugs (R). See figure 7.
NOTE: Either side of the rear hopper tube can face up.
REAR
HOPPER
TUBE
_:__ UPPER
FIGURE 7
STEP
12
- ASSEMBLE TUBES TO BAG
, Unfold the hopper bag, reverse the fold of the mesh
wind screen and then lay the bag out flat with the wind
screen on top=
, insert the ends of the assembled upper hopper tubes
down through the stitched sleeves in the sides of the
hopper bag and then slide the tubes back underneath
the wind screen. See figure 9.
STmTCHED SLEEVE
UPPER
HOPPER
TUBE
FIGURE 9
STEP 11 - ASSEMBLE LOWER TUBES
, Fit the ends of the two lower hopper tubes into the
ends of a rear hopper tube. Align the holes in the
ends of the tubes and insert plastic plugs (R). See
figure 8=
, insert a clevis pin (O) from the outside into each lower
hopper tube and secure it with a hair cotter pin (M).
See figure 8=
NOTE: Either side of the rear hopper tube can face up.
Place the assembled lower hopper tubes into the
bottom of the hopper bag and then slide the tubes to
the back of the bag. See figure 10.
Attach the ends of the lower hopper tubes to the
inside of the upper hopper tubes using two clevis pins
(N) inserted from the inside, and two hair cotter pins
(M)= See figure 10=
UPPER HOPPER
REAR PLASTIC
HOPPER PLUG (B)
TUBE_,_ _ CLEVIS PiN (O)
TUBE
FIGURE 8
HAURCOTTER
PUN(M)
LOWER HOPPER TUBE _
3LEVmS PmN(N)
FIGURE 10
7