Kenmore 110.8708 Use & Care Manual page 8

Power Supply Cord Direct Wire
Fire Hazard
Use a new UL misted 30 amp power supply cord.
Use a UL misted strain relief,
Disconnect power before making emectrica_ connections,
Connect neutram wire (white or center wire) to center
terminaa (silve0,
Ground wire (green or bare wire) must be connected to
green ground connector,
Connect remaining 2 suppmy wires to remaining
2 terminals (goBd).
SecureBy tighten aH emectricat connections,
FaiBure to do so can resumt in death, fire, or
electrical shock,
Fire Hazard
Use 10 gauge somid copper wire,
Use a UL misted strain relief,
Disconnect power before making emectricai connections.
Connect neutral wire (white or center wire) to center
terminal (simve0.
Ground wire (green or bare wire) must be connected to
green ground connector,
Connect remaining 2 suppmy wires to remaining
2 terminals (gored).
Securety tighten aH emectdcal connections.
Failure to do so can resumt in death, fire, or
emectrical shock.
1. Disconnect power,
2. Remove the hold-down screw and terminal block cover. ...................................................... A
3.
A. Neutral ground wire
B. External ground conductor screw
C. Center, silver-colored terminal block screw
D. Terminal block cover and hold-down screw
Install strain relief.
Style 1: Power supply cord strain relief
Remove the screws from a 3/4"(1.9 cm) UL listed strain
relief (UL marking on strain relief). Put the tabs of the two
clamp sections into the hole below the terminal block
opening so that one tab is pointing up and the other is
pointing down, and hold in place. Tighten strain relief
screws just enough to hold the two clamp sections
together.
A. Strain relief tab pointing up
B. Hole below terminal block opening
C. Clamp section
D. Strain relief tab pointing down
Put power supply cord through the strain relief. Be sure
that the wire insulation on the power supply cord is inside
the strain relief, The strain relief should have a tight fit with
the dryer cabinet and be in a horizontal position. Do not
further tighten strain relief screws at this point.