HP 4400 Replacement Instructions page 4

3. Place the cover on the controller module rails and slide the cover
over the controller until the latch clicks in place.
Figure 8 Installing the controller cover
4. Move the small form-factor pluggable (SFP) modules from the
controller being replaced to the new controller.
5. Reinstall the controller.
a. Push the controller halfway into the controller enclosure (1,
Figure 9).
b.
Attach the Fibre Channel cables to the two controller device
ports (DP1–A and DP1–B).
NOTE:
Inserting a controller without connecting the device
port Fibre Channel cables may result in soft
diagnostic errors being reported.
c.
Fully insert the controller. Move the mounting latch to the left
until fully engaged and the controller is fully seated in the
enclosure (2). The controller should power up automatically.
Tighten the controller latch thumbscrew.
Figure 9 Installing a controller
6. Use the controller console port (or Ethernet port) to configure the
embedded switch settings to establish a connection to your network.
See the HP StorageWorks 4400 Enterprise Virtual Array installation
guide for the configuration procedures.
7.
15785
8.
9.
Verifying proper operation
After replacing the controller, check the following to verify the component
is operating properly:
•
•
2
1
15786
Page 4
If you have a saved backup switch configuration file, download
and restore the configuration to the controller switch. See the Fabric
OS administrator guide for the procedure.
If you do not have a saved backup switch configuration file, you
should verify that the replacement controller does not have an
existing zoning configuration before connecting servers to the array
or inserting the array into an existing fabric. Otherwise, serious
issues may occur.
To check for an existing zoning configuration, log into the switch
and enter:
Swd77> cfgshow
If zoning information is displayed, enter:
Swd77> cfgclear
Swd77> cfgdisable
Check that the switch domain ID is set to 1 (the default) or, if you
are connecting the array to an existing fabric, verify that the ID is
not being used by another switch. See the Fabric OS administrator
guide for the procedure.
Attach the Fibre Channel cables to the switch ports.
HP recommends that you check and update the switch firmware to
the latest supported version. See the Fabric OS administrator guide
for detailed procedures.
NOTE:
Wait approximately 3 minutes for the system to check the
component status.
Verify the controller health green LED is lit (see
reseating the controller in the enclosure.
From HP Command View EVA, navigate to the component as de-
scribed in the Verifying component failure
status. It should be (Good).
Table 1). If not, try
section, and check the