Installing An Optional Optical Drive - HP Point of Sale rp5000 Hardware Reference Manual

Installing an Optional Optical Drive

Ä
Ä
Hardware Reference Guide
CAUTION: If an optical drive is installed, you cannot install a secondary
hard drive. There are not enough power supply connectors to support this
configuration. Doing so could result in damage to the computer.
To install an optional optical drive:
1. Turn off the computer properly through the operating system,
then turn off any external devices.
2. Disconnect the power cord from the power outlet and disconnect
any external devices.
3. Remove the computer access panel and front bezel (see
"Removing the Computer Access Panel and Front Bezel"
chapter).
4. Remove the optical drive if present (see
Drive or Diskette Drive"
5. Install two M3 metric guide screws in the lower holes on each
side of the drive.
CAUTION: Use only 3/16-inch or 5-mm long screws as guide screws.
Longer screws can damage the internal components of the drive.
www.hp.com
"Removing an Optical
in this chapter).
Hardware Upgrades
in this
2-19