Running The Setup Utility After Creating The Initial Software Configuration - Dell 3-DNS Administrator's Manual

Chapter 3
Running the Setup utility after creating the initial
software configuration
3 - 14
2. Edit the zone file information as required.
For help with the NameSurfer application, click Help in the
NameSurfer navigation pane.
Note
Remember that if you run the 3-DNS Controller in bridge or router mode,
the system is not authoritative for any domains, so the NameSurfer
application is not available to manage any zone files.
You normally run the Setup utility when the system is first installed as part
of the installation procedure. However, you can also use the command line
Setup utility to change existing settings at any time. This section describes
running the Setup utility to change settings after you run it initially.
To run the Setup utility from the command line, type in the following
command:
setup
After you complete the initial configuration, the Setup utility presents a
menu of individual configuration options.
The Setup utility menu is divided into two different sections, Required and
Optional. The Setup utility includes the following required configuration
options:
• Set the default gateway pool
• Configure VLANs and networking
• Set host name
• Configure web servers
• Set the root password
The following configuration selections are optional:
• Configure DNS
• Configure FTP
• Set keyboard type
• Define time servers
• Configure NameSurfer
• Initialize the iControl portal
• Configure RSH
• Configure SSH