NEC LT50 Quick Manual

Quick Connect Guide
Step1
Connect the supplied 15pin-15pin signal cable.
Mini D-Sub 15 pin
connector
RGB cable (supplied)
Always power down before you make any connections.
Step2 Connect the supplied power cable.
D IO
A U
Step3 Turn on the projector.
A U
D I O
NOTE: To turn off the projector, press and hold the POWER button for a
minimum of two seconds.
For older Macintosh comput-
ers which do not have a mini
D-Sub 15 pin connector, use
a commercially available pin
adapter to connect to your
AU
DIO
Macintosh's video port. RG
B
S-V
IDE
O
PC
CO NT
RO
L VID
EO
US
B PC
CA RD
AC
IN
A U
D IO
R G
B
Power cable (supplied)
IN
A C
R D
C A
P C
B
U S
E O
V ID
ID E O
S -V
B L
R G R O
N T
C O
P C
Step4 Set up the Projector
To adjust the projector's focus use the Focus ring on the lens.
R G
B I
N P
U T
Adjusting the Tilt Foot
S - V
ID E
O
P C
C O
N T
R O
L
V ID
E O
1
1. Lift the front edge of the projector.
2. Press the Tilt button on the top of the projector to extend the Adjustable Tilt
Foot.
3. Press and hold the Tilt button.
4. Lower the front edge of the projector to the desired height and release the Tilt
button to lock the Adjustable Tilt Foot.
• If the projected image does not appear square to the screen then use keystone correction for
proper adjustment. See page 31 or 37 of the supplied user's manual.
Spacer
MultiSync LT150/LT85
4
2
1
To fine-adjust the height of the rear foot,
remove the spacer and rotate the rear foot
to the appropriate height.
Focus ring
3
4