Preventing The Plasma Display From Falling Over - Pioneer Elite PRO-110FD Operating Instructions Manual

Preparation
05
Preventing the plasma display from
falling over
After installing the stand, be sure to take special care to ensure
that the plasma display will not fall over and is stabilized to both
the wall and rack.
Stabilizing on a table or rack
Stabilize the plasma display as shown in the diagram using the
supplied plastic bands and screws.
Note
• To stabilize the plasma display on a table or rack, also use
commercially available wood screws that have a nominal
diameter of 4 mm (5/32 inch) and that are at least 20 mm
(13/16 inch) long.
20 mm min.
(13/16 inch)
Supplied screw
Wood screw
(M4 x 10 mm)
(commercially available,
4 mm x 20 mm min.)
(5/32 inch x 13/16 inch)
Drill a hole in the middle at the rear of the tabletop panel before
using a wood screw. Perform this work the same way on the left
and right sides.
26
En
(PRO-150FD)
Supplied Supplied
screw screw
Wood screw
20 mm min.
(13/16 inch)
Supplied screw Wood screw
(M4 x 10 mm) (commercially available,
4 mm x 20 mm min.)
(5/32 inch x 13/16 inch)
Drill a hole in the middle at the rear of the tabletop panel before
using a wood screw. Perform this work the same way on the left
and right sides.
Using a wall for stabilization
1
Attach falling prevention bolts (hooks) to the plasma
display.
2
Use strong cords to stabilize it appropriately and
firmly to a wall, pillar, or other sturdy element.
Perform this work in the same way on the left and right sides.
Note
• Use hooks, cords and fittings that are available on the market.
Recommended hook: Nominal diameter 8 mm, length 12 mm
to 18 mm (0.5 inches to 0.7 inches)
1. Hook
2. Cord
Fitting
(PRO-110FD)
4
5
Supplied screw Supplied screw
Wood screw
12 mm to 18 mm
(0.5 inches to 0.7 inches)
4
5