D-Link DG-102SP Manual page 9

Getting Started
Installation
Do not place heavy objects on the DG-102SP at any time. Placing
the DG-102SP in a well ventilated area is very important. Not doing
so may cause damage to the unit.
When installing the unit on a desktop or shelf, the rubber feet in-
cluded with the device should be attached. These cushioning feet
should be attached to the bottom corners of the device.
Connecting the Network Cable
Category 3, 4 or 5 UTP cable can be used to make the Ethernet connection to
your router.
Connecting the VoIP Gateway to a Computer
The DG-102SP requires a straight-through cable when connecting to a
computer. make sure that your IP address on your Ethernet card is in the same
subnet as the DG-102SP otherwise it will not connect
Connecting the VoIP Gateway to a Hub/Switch
To connect the device to either a hub or switch, you must connect the straight-
through cable to the LAN port.
9