Package Contents - DeWalt DCF403 Manual

Hide thumbs Also See for DCF403:
Table of Contents

Advertisement

English
All lithium‑ion batteries have the Wh rating marked on the pack.
Furthermore, due to regulation complexities, D
not recommend air shipping lithium‑ion battery packs alone
regardless of Wh rating. Shipments of tools with batteries (combo
kits) can be air shipped as excepted if the Wh rating of the battery
pack is no greater than 100 Wh.
Regardless of whether a shipment is considered excepted
or fully regulated, it is the shipper's responsibility to consult
the latest regulations for packaging, labeling/marking and
documentation requirements.
The information provided in this section of the manual is
provided in good faith and believed to be accurate at the time
the document was created. However, no warranty, expressed or
implied, is given. It is the buyer's responsibility to ensure that its
activities comply with the applicable regulations.
Storage Recommendations
1. The best storage place is one that is cool and dry away from
direct sunlight and excessive heat or cold. For optimum
battery performance and life, store battery packs at room
temperature when not in use.
2. For long storage, it is recommended to store a fully charged
battery pack in a cool, dry place out of the charger for
optimal results.
nOTE: Battery packs should not be stored completely depleted
of charge. The battery pack will need to be recharged before use.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual, the
labels on the charger and the battery pack may show the
L
following pictographs:
Read instruction manual before use.
p
Refer to Technical Data for charging time.
q
Do not probe with conductive objects.
r
Do not charge damaged battery packs.
s
Do not expose to water.
t
Have defective cords replaced immediately.
u
Charge only between 4 ˚C and 40 ˚C.
v
Only for indoor use.
x
Discard the battery pack with due care for
the environment.
8
y
WALT does
e
z
Battery Type
The following tools operate on an 18‑volt (20V Max) battery
pack: DCF403, DCF414
Refer to Technical Data for more batteries information.

Package Contents

The package contains:
1 Riveter
4 Nosepieces (DCF403)
3 Nosepieces (DCF414)
1 Set of spare jaws
Li‑Ion battery pack
1 Instruction manual
nOTE: Battery packs, chargers and kitboxes are not included
with N models. Battery packs and chargers are not included with
NT models. B models include Bluetooth® battery packs.
nOTE: The Bluetooth® word mark and logos are registered
trademarks owned by the Bluetooth®, SIG, Inc. and any use of
such marks by D
trade names are those of their respective owners.
Check for damage to the tool, parts or accessories which may
have occurred during transport.
Take the time to thoroughly read and understand this manual
prior to operation.
Markings on Tool
The following pictograms are shown on the tool:
a
g
f
n
Date Code Position (Fig. B)
The production date code
by a 2‑digit week and is extended by a 2‑digit factory code.
Description (Fig. A)

Nosepieces
1
Screw cap
2
Nose housing
3
Charge D
WALT battery packs only with designated
e
D
WALT chargers. Charging battery packs other than
e
the designated D
WALT batteries with a D
e
charger may make them burst or lead to other
dangerous situations.
Do not incinerate the battery pack.
WALT is under license. Other trademarks and
e
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
Visible radiation. Do not stare into light.
consists of a 4‑digit year followed
 14 
WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
WALT
e

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dcf414

Table of Contents