Guide to diagnostics of NEW COLLECTION EWM09312 electronic controls
E83: Error reading the programme selector code
E83
Selector position code not envisaged by the configuration data or configuration error
Turn the appliance on, turn
the programme selector to
every setting: wait at least
10 seconds on each of the
settings before moving on to
the next one. Is alarm E83
between the control panel
Is it difficult to turn the knob?
Repair the coupling between
the control panel/selector knob.
Repeat the diagnostic cycle to
check for any further alarms.
E86
Replace the display board and run the diagnostic cycle to check for any further alarms.
E87
Replace the display board and run the diagnostic cycle to check for any further alarms.
T.S.-mdm FCPD-dp Quality tb
shown again?
YES
Check for any friction
and the knob.
YES
E86: Programme selector configuration error
E87: Display board microprocessor faulty
!
Check that all the connectors are correctly inserted
Repeat the diagnostic
cycle to check for any
NO
further alarms.
Replace the display board
and repeat the diagnostic
NO
cycle to check for any
further alarms.
If there are burns on the circuit board,
!
!
Check that all the connectors are correctly inserted
If there are burns on the circuit board,
!
!
Check that all the connectors are correctly inserted
If there are burns on the circuit board,
!
50/61
E83
see page 59
E86
see page 59
E87
see page 59
599 74 42-27 Rev.00