Table of Contents
Advertisement
Available languages
Available languages
AFC (Automatic Frequency Control) circuit prevents drifting of
the properly
tuned-in
FM
station.
For reception
of a weak
signal station located near strong signal station, set the AFC
button @@ to the ''OFF"
position.
* In the area comparatively near the broadcasting station, the
telescopic antenna
is sufficient for use.
!n the area where
electric signals are weak,
however,
connect an FM feeder
antenna,
sold
on
a market,
to the
FM
external
antenna
socket and spread it on the ceiling or wall, aligning the
horizontal section of the antenna
to the best direction.
(See diagram
)
* In areas
with
very
weak
signal,
install
an
exclusive
FM
antenna and connect it to the FM external antenna socket.
(See diagram
)
SW reception: Extend the Telescopic antenna (aerial) ©) to its full
length.
MW
and LW reception: The built-in ferrite-core antenna
(aerial)
guarantees good reception under normal condition.
Rotate the
unit and find the position in which the best reception is obtained.
5. Adjust the Volume, Bass, Treble and Balance control (6 ,
j
@ and @ .
6. To turn
off the radio,
set the
Function
selector @to
the
"TAPE" position.
FM stereo indicator: If the FM stereo indicator light is ON, the
station is boradcasting stereo programme. Set the Mode switch
@3 to "STEREO"
or "WIDE" position.
If the stereo indicator
light should go off later the station is no longer transmitting
stereo programme,
therefore change the Mode switch @3) to
"MONO" position.
LOUDNESS
SWITCH:
At low listening levels, set the Loudness
switch
for
better
sound.
The
Loudness
switch
(4 compensates
for the
decreased
response to bass and treble frequencies of the human
ear at low listening levels.
As the listening level is increased, the
amount of compensation is progressively reduced.
INSERTION
OF CASSETTE:
Depress the Eject button (1) to open the cassette lid
and insert the cassette with its full reel on the right and the open-
ing up.
When
the cassette
is fully recorded
or played back,
it may
be
SELECTION
OF TAPE
TYPE: When
using chromium
dioxide (CrO2) tape, Tape
selector @5) should be set to the CrO2 position for optimum
per-
formance.
In order to avoid faulty recording this selector should
be checked before each recording.
Playback is not affected by this selector.
Advertisement
Table of Contents
