Table of Contents
Advertisement
hn..n.
zuuj
i:jDri
UiL V 1LC 1 55
1MU
IN U, 1014
f.
0
OPERATING PROCEDURES
1. Before plugging in the air compressor, set the adjust¬
able pressure valve to "Start". Make sure the "ON-
OFF" switch is in the "OFF position
2. Connect the air hose to the air outlet adapter. Tiqhten
securely.
3. Connect the air tool or accessory to the air hose
Tighten securely.
4. Plug the power cord Into the grounded outlet.
5. Start the compressor by setting the "ON-OFF switch
to the "ON" position.
WARNING
TOO MUCH AIR PRESSURE COULD CAUSE
AN AIR TOOL OR VEHICLE TIRE TO RUP¬
TURE OR EXPLODE. CAREFULLY FOLLOW
STEPS 6 AND 7 EACH TIME YOU USE YOUR
COMPRESSOR.
6. Check the manufacturer's maximum pressure rating
for the air tool, accessory or vehicle tire being used.
The air compressor outlet pressure must never
exceed the maximum pressure rating.
7. Slowly increase the pressure setting of the adjustabl
pressure valve, tou should be able to hear and fe<
air pressure being relieved by the adjustable pressur
valve. If pressure is not being relieved, turn the a
compressor off immediately. The pressure valv
must be replaced.
CAUTION
Compressed air from the outfit may contain
water condensation and oil mist. Do not
spray unfiltered air at an Item that could be
damaged. Some air operated tools or
devices may require filtered air. Read the
Instructions for the air tool or device.
NOTE
If the air compressor has been briefly turned off,
the adjustable pressure valve must be reset to
the "Start" position. The air compressor will not
start with backpressure applied to the piston.
MAINTENANCE
WARNING
]
D,4f»NG MAINTENANCE, YOU COULD BE EXPOSED TO VOLTAGE SOURCES rOMPnceern
awn m ecnnec PART®' PERSONAL INJURIES CAN OCCUR. UNPLUG THE COMPRESSOR
TWP Q^Ei^DD^L^hk.l!?r-«RESSURE
BY "TURNING THE ADJUSTABLE PRESSURE VALVE TO
THE START POSITION BEFORE DOING ANY MAINTENANCE OR REPAIR
°
Air Intake Filter - Replacement
Motor
NOTE
Keep air intake filter clean at all times. Do not
operate the compressor with the filter removed.
A dirty air intake filter will not allow the compressor to
operate at full capacity. When the fitter becomes dirty, it
must be cleaned or replaced. To replace the filter, simply
pull it out and replace with a new one. If it Is dirty, simply
pull it out - you may wash it with a mild detergent and
warm water.
.
t
....— ~
i
cooi
inarmai overload prc
petor If the motor overheats for any reason, the ove
load protector will shut off the motor. The motor must b
allowed to cooL The motor will automatically re-stai
after the motor has cooled.
NOTE
If the overload protector shuts the motor off fre¬
quently, check for a possible voltage problem
Low voltage can also be suspected when:
1. the motor does not get up to full power or
speed;
2. fuses blow out when starting the motor;
3. lights dim and remain dim when motor is
started and running.
7
Advertisement
Table of Contents
