Table of Contents
Advertisement
Warning: This device complies with Part 15 of the FCC Rules, Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable pro¬
tection against harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that inter¬
ference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between, the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is con¬
nected.
— Consult the dealer or an experienced radio /TV technician for help.
Caution to the user:
Changes or modifications not expressly approved by the manufacture could
void the user's authority to operate the equipment.
Notes
*
This unit uses 8mm video format cassettes.
*
It records and plays back in the SP mode (14.3 mm/ sec).
*
It cannot record and play back in the LP mode (7.2 mm / sec).
MOISTURE
Avoid operating your camcorder immediately after moving it from a cold place to a warm, humid
place. Give the camcorder 2 to 3 hours to stabilize in the ambient conditions of the surroundings
before inserting a cassette. When moved from a cold place to a warm, humid place, moisture may
condense on the head drum inside the machine. This moisture could cause the tape to stick to the
head wheel and damage the headwheel or tape.
When a small amount of moisture is sensed, "TAPE" flashes in the viewfinder or on the LCD moni¬
tor. Remove the cassette and set the CAM /OFF /VIDEO switch to OFF, then wait for about one
hour.
VIV1-H675LA/VM-E575LA/VIVI-E573LA
E3
Advertisement
Table of Contents
