Yamaha K-1020 Owner's Manual page 17

High frequencies іп the playback sound are emphasized and
unpleasant to listen to, and noise level (hiss) is also high.
Playback sound is muffled and high frequencies are inaudible.
Playback sound balance is poor and sound seems muffled.
Sound seems faint.
Playback sound balance is poor. Sounds are sometimes too
loud, sometimes too soft, and meter deflection is abnormally
high.
When playing back tapes recorded on other decks, meter
deflections are greater (smaller) than when recording.
Does not operate when record standby button is pressed.
Recordings cannot be made.
Recordings cannot be made with TIMER REC (deck only
plays back). |
• dbx ог Dolby-recorded tape is played back іп NR OFF position.
* Normally-recorded tape is played back in DOLBY or dbx.
е Heads are dirty.
. * Heads are magnetized.
* dbx-recorded tape is played back in DOLBY B, C or NR OFF
position.
* Normal or DOLBY-recorded tape is played back through dbx.
* Basic levels are different for different cassette decks.
* Мо cassette tape has been loaded.
* Protective accidental erasure tabs on cassette have been
broken off.
* Recording level controls (PRESET REC LEVEL) are set too low.
е MASTER FADER conrol is set too low.
e Protective accidental erasure tabs on cassette have been
broken off.
• Play back in appropriate DOLBY or dbx position.
. * Play back in NR OFF position.
ə Clean heads and carry out demagnetization with head demagnetizer.
* Play back in dbx position.
е Play back in the position in which it was recorded.
* This is not a fault.
ә Load a cassette tape.
• Replace cassette tape, or cover tab holes with tape.
ә Adjust level with the level control.
> Set to "0" position.
е Replace cassette tape, or cover tab holes with tape.
16