Installation - HP 84811A Operating And Service Manual

HP 84811A
Table 2. Recommended Test Equipment
Page 3
Instrument Type Critical Specifications Suggested Model
Peak Power Meter Compatability with HP 8900C
Peak Power Sensor
Digital Voltmeter Resolution = at least HP 3455A
0.0001 Vdc; Range = 41.5 Vde
Power Supply Regulation —load effect 5 mV, source HP6203B
effect 3 mV. Range: 0—1.5 V min.
Periodic and random deviation: 200
u Vrms, 1 mV peak to peak
Potentiometer Non-wirewound 50 Ohm. 1/4 Watt HP 2100-0671
Sweep Oscillator HP 8620C
Mainframe |
RF Plug-in HP 86290A
Microwave Amplifier HP 489A, 491C, 493A, 495A
Coaxial Step Attenuator 1 dB/step HP 8494B
Dual Directional HP 11692D
Coupler
Power Meter (2 required) HP 436A
Power Sensor | Compatability with HP 8481A
2 required) | HP 436A Power Meter
Coaxial Attenuator | 2098 HP 84918 Opt. 010
Type N Coaxial Short HP 11512
Type N Coaxial Open HP 1250-0916, Body
(made from the HP 1250-0016
following parts): Snap Ring
HP 1250-0918 Nut
———————
ችን ን ካጨ eMe al e Mr rr A AUS MM ና ELE +
Mating Connectors. TherfinputofthePeak Power
Sensor can only be connected to a50 ohm type N
female connector that is compatible with US
MIL-C-39012.
INSTALLATION
Initial Inspection
Inspect the shipping container for damage. If the
shipping container or packaging material is dam-
aged, it should be kept until the contents of the
shipment have been checked mechanically and
electrically. If there is mechanical damage orifthe
instrument does not pass the performance tests,
notify the nearest Hewlett-Packard office. Keep
the damaged shipping materials (if any) for inspec-
tion by the carrier and a Hewlett-Packard
representative.
Operating Environment
The operating environment for the Peak Power
Sensor should be within the following limits:
Temperature: 0 to +55°C
Relative humidity: less than 95% at 40°C
Altitude: less than 4600 metres (15 000 ft).
Storage and Shipment
Storage Environment. The instrument should be
stored in a clean, dry environment. The following
limitations apply to both storage and shipment:
Temperature: —40 to +75°C
Relative humidity: less than 95% at 40°C
Altitude: less than 15 300 metres (50 000 ft).
Preparation for Use
interconnections. The Peak Power Sensor and the
peak power meter are integral parts of a measure-
ment system. Before measurements can be per-
formed, the peak power meter and Peak Power
Sensor must be connected.