Sony RSE-500 Operating Instructions Manual page 38

Starting Communication
If the connection failed
If the system cannot make a connection with the
remote site, the following message and the ISDN cause
code appear for five seconds and the DIAL LIST menu
appears again.
CONNECTION FOILED !
CAUSE CODE = 017
For
details on the ISDN cause code, see "ISDN cause
codes
"
on page A-7 (EN).
To return to the main menu
Move the cursor to <EXIT> and pre.ss ENTER. The
main menu appears.
To connect to an unregistered remote site
1
If the DIAL LIST menu is displayed, select
<EXIT> to display the main menu.
If you have disabled the main menu, the following
screen is displayed when you select <EXIT>.
Proceed with the process from this screen.
[bfflL LIST!
DIPL KEY
BUSY
SETTING
When using the Remote Commander, skip the
operation above.
2
Select DIAL KEY. When using the Remoter
Commander, press DIAL.
The following screen appears.
-KEY-
SELECT:[il] 2B SINGLE DUAL
1ST 01AL:
[**********************]
SUB address:[**********1
2ND dial:
I**********************!
SUB address:[**********]
012345B789
B5
<EXIT> <DIAL>
3
Select the transmission rate (via an ISDN line from
1B or 2B. via the V.35 interface from SINGLE or
DUAL) using ♦ or then press ♦.
4
Enter the telephone number for BI -channel of the
remote site using or <►, then press ENTER one
by one.
When using the Remote Commander, you can
enter the number using the number keys.
The telephone number is entered in the telephone
number box.
•An asterisk is displayed where nothing is entered.
5
Press
♦
and enter the subaddress for BI -channel of
the remote site using ♦ or
then press ENTER
one by one.
When using the Remote Commander, you can
enter the number using the number keys.
The subaddress is entered in the subaddress box.
• An asterisk is displayed where nothing is entered.
Press ♦ and repeat steps
4
and
5
to enter the
.second telephone number and subaddress.
After entering the subaddress for the second
telephone number, move the cursor to <DIAL>
using ♦, then press ENTER.
When the remote site is connected, the picture
from the remote site is displayed.
Note
The subaddress function may not be worked properly
depending on types of switchboards.