Table of Contents
Advertisement
en-us_main.book.book Page 11 Wednesday, July 12, 2023 4:56 PM
Installing the Charging
Station
CAUTION
• Do not allow children or pets to hang onto the
charging station. They could be injured or cause
damage to the appliance.
• Take care not to drop the product parts while
unpacking them to avoid appliance damage or
personal injury.
NOTE
• The cost of a service call to install or reinstall the
charging station is not covered under the
warranty.
Installation
Follow the steps below to install the charging
station on a hard and level floor.
CAUTION
• Do not install on carpeted floors or rugs. The
product may fall, causing injury or damage.
1
Place the charging station on a flat, hard
surface with the long side facing forward.
• Install the charging station with at least
2" (5cm) of clearance in the rear. If you plan
to store the mop nozzle on the station,
allow more than 2" (5 cm).
• Keep an 8" (20cm) radius in the front clear
of obstacles in order to open the doors of
the station.
2
Using the anti-tip kit, fix the product firmly to
the wall.
3
Plug the power plug into the outlet.
• When the power plug is connected
correctly, the status display flashes, and the
product setting is initialized. Once
initialization is completed, the status display
turns off.
Anti-tip Kit Installation
The anti-tip kit is designed to secure the product to
the wall in order to prevent it from tipping over
and causing personal injury or damage to itself or
the floor.
WARNING
• Carefully read and follow the guidelines in order
to prevent property damage or personal injury.
• Do not lean against the product or place a heavy
object on top of it.
• Manage and supervise children or pets to
prevent them from knocking into or climbing on
the product.
• If you prefer not to install this kit immediately,
ensure that you keep it out of the reach of
children.
• Do not use this kit for purposes other than the
installation of the charging station.
• Wear gloves and protective clothing in order to
prevent personal injury.
• When drilling a hole in concrete, take caution
and wear protective goggles.
• Before drilling into a wall, make sure that there
are no vents, gas or water pipes, or electrical
cables behind the wall.
INSTALLATION
11
Advertisement
Table of Contents
