Table of Contents
Advertisement
CONNECTING
EXTERNAL VIDEO SOURCES
The exact arrangement
you use to connect the VCR, camcorder, laserdisc player, DVD player, or HDTV Set Top Box to your Plasma
TV is dependent on the model and features of each component.
Check the owner's manual of each component for the location of
video and audio inputs and outputs.
The following connection diagrams are offered as suggestions.
However, you may need to modify them to accommodate
your
particular assortment
of components
and features.
For best performance,
video and audio cables should be made from coaxial
shielded wire.
Before Operating
External Video Source
The input mode is changed when the VIDI~VID5
button is pressed as shown below. Connect an external source to the INPUT
terminal, then press the VID1-VID5
button as necessary to view the input source (see page 31).
INPUT MODE SELECTION
ORDER
(ANTENNA)
(INPUT)
3:32 PM
AntA
32
Stereo
ViOl
3:32 PM
YPBPR:_
VlD_
Stereo
10801Format
ANT
t
©
CONNECTING
A MONAURAL AUDIO SOURCE TO INPUT2~INPUT5
1,
Connect the cable from the VIDEO OUT of the VCR or the laserdisc player to the INPUT (VIDEO) jack, as shown on the AVC
Center below,
2,
Connect the cable from the AUDIO OUT of the VCR or the laserdisc player to the INPUT (MONO)/L(AUDIO)
jack,
3,
Press the VID2~VID5 button to view the program from the VCR or the laserdisc player, The VIDEO label disappears
automatically after approximately four seconds,
4,
Press the ANT button to return to the previous channel,
Rear Panel of AVC Center
) i
@ _
@
I
VCR
14
Advertisement
Table of Contents
