Sony MHC-GX555 Operating Instructions Manual page 30

The album name, track title and ID3 tag
information do not appear correctly.
• Use a db, c that conforms x_ith 1SO9660 Lcxel 1,
Level 2 or Joliet in Ihe expansion format.
• The disc ID3 tag is not ver. I nor ver. 2.
• Only up to 30 characters of ID3 tags are displayed.
• The characters that can be displayed by this
system arc as l_)llows:
Upper cases IA to Z)
Numbers (0 to 9)
Symbols I'< > "-+, / @ [ \ ] )
Other characters may not be displayed correctly.
Tuner
Severe hum or noise/stations cannot be
received. ("TUNED" or "STEREO" flashes in
the display.)
• Set the proper band and frequency (page 14).
• Connect the antenna properly (page 7).
• Find a place and an orientation that provide good
reception, then set up the mtenna agfin. If you
cannot obtain good reception, _e reconln/end yo/i
connect a commercially available external
ilntenniL
• The supplied FM lead antenna receives signals
along its entire length, so make sure you extend it
fully.
• Locate the antennas as far away from the speaker
cords as possible.
• Try turning off surrounding electrical equipment
• Set "CD POWER OFF" by CD power manage
function (page 15).
A stereo FM program cannot be received in
stereo.
• Press FM MODE rq_eatedly until "STEREO'
ap?ears.
Noise increases or the high frequencies are
erased.
• The rccord/playback heads ire magnetized
Demagnetize them (page 33).
The tape does not record.
• No cassette is loaded Load a cassette
• Tile tab has been removed from tile cassette
Cover the broken tab with adhesive tape
(page 33)
• The tape has wound to the end
If the system still does not
operate properly after performing
the above measures, reset the
system
as follows:
Use buttons on the unit for the operation
1
Disconnect the power cord.
2 Reconnect the power cord.
3 Press I/_ to turn on the system.
4 Press i, ILLUMINATION and DISC 1 atthe
same time.
The system is reset to the Mctory settings You
should set the settings you made. such as the
preset stations, clock, and timer
Note
You cannot rescl the system to the factory settings in
Power Saving Mode (page 24)
Tape deck
The tape does not record or play, or there is a
decrease in sound level.
• The heads arc dirty Clean them (page 33)
• The record/playback heads arc magnetized
Demagnetize them (page 33).
The tape does not erase completely.
• The record/playback
heads arc m:,gnctized.
Demagnetize them (page 33).
There is excessive wow or flutter, or the sound
drops out.
• The capstans or pinch rollers are dirty Clean them
(page 33).
30 G8