Table of Contents
Advertisement
TROUBLESHOOTING
If a fault occurs, run through the points listed below before taking your changer for repair. If the fault remains, try to clear it by
switching the changer off and on again. lf this also fails to help, consult your dealer or an Authorized Philips Cervice Center.
Under no circumstances should you repair the changer yourself, as this will invalidate the warranty!
SYMPTOM
POSSIBLE CAUSE
REMEDY
— The current CD has been loaded
upside down.
— No CD inserted.
— The current CD is badly scratched or
dirty.
— Moisture condensation on the lens.
— Playback does not start or
interruption of playback occurs.
Reload the CD, label side up.
Insert the CDs, label side up.
Clean the CD with a soft, lint-free
cloth.
Leave the CD changer in a warm
environment until the moisture
evaporates.
Clean the CD with a soft, lint-free
cloth.
— Sound skips (at the same part).
— The current CD is dirty.
— The current CD skips tracks.
— The CD is damaged or dirty.
Replace or clean the CD.
Switch off SHUFFLE or clear
program.
— Playback does not start from the
first track (of the current CD),
— PRG (program) or SHUFFLE
activated.
Check connections.
Find another place for the unit or
change connections.
— No sound or bad sound.
— Loose or wrong connections.
— Strong magnetic fields near the CD
changer.
Set level control.
Clean plug.
= No sound or bad sound on
headphones (CDC 926 only).
— Level control set to — position.
— Headphones plug is dirty.
— Volume is too low.
— Sound level has been adjusted too
low with the -VOLUME + keys on
the remote control (CDC 926 only).
Adjust sound level.
- Remote control does not function
— Batteries are empty.
(CDC 926 only).
Replace the batteries.
e Use remote control receiver EM
2200/2201.
e Reduce the distance between
remote control and CD changer.
— The distance between remote
control and CD changer is larger
than 10 metres.
~ Remote control commands are not
properly received (CDC 926 only).
17
Advertisement
Table of Contents
