Kenwood NEXEDGE NX-200 Function Reference page 513

22
FUNCTION PORTS
The transceiver is equipped with function ports that can be programmed using KPG-111D/ DN.
22.1 Universal Connector (Portable Only)
For Portable, the transceiver is equipped with a function port that can be programmed for use with the 14-pin universal
connector located on the side of the transceiver. The Man-down tilt switch, Vibrator unit and GPS receiver unit can be
connected to the transceiver via the universal connector.
Assigning Functions to the Universal Connector
Pin 11 of the universal connector can be used with the following functions depending on the user's application.
Function
5 V power source is supplied to pin 11 of the universal connector when AUX is enabled by pressing the AUX key
AUX or selecting "AUX" after entering Menu Mode by pressing the Menu key. The transceiver stops supplying 5 V
when AUX is disabled. A maximum of 200 mA current can be supplied to pin 11.
5 V power source is supplied to pin 11 of the universal connector at 500-ms intervals for 10 sec if activation
Vibrator conditions for the vibrator are satisfied while Vibrator is enabled. The vibrator unit (KCT-48VU) connected to the
universal connector notifies a user by vibrating.
This configuration applies when using external devices that always require a power source, such as the KMC-25
speaker microphone and headset.
The transceiver's behavior varies as below depending on the configuration for Output Control by SSW.
Always 5 V (high) If the Output Control by SSW is configured to be enabled:
The 5 V power source is supplied to pin 11 if pin 1 (SSW) of the universal connector is low level.
If the Output Control by SSW is configured to be disabled:
The 5 V power source is supplied to pin 11 regardless of the status of pin 1 (SSW) of the universal connector.
5 V power source is always supplied to pin 11 of the universal connector. This configuration is applied when the
HRS Adapter KCT-51 is used. HRS Adapter can be used to easily connect audio accessories or similar to the KCT-51. This
configuration is also applied when an external device that always requires a power source is used.
Note
• Refer to 3.4 Using Menu Mode on page 23
• The Vibrator is automatically enabled when the transceiver is turned ON if the Vibrator key is not configured while "Vibrator" is
configured for Universal Connector Pin Number 11.
Configuration using KPG-111D/ DN
• Configuring the Universal Connector Pin Number 11 (
• Configuring the Output Control by SSW to be enabled or disabled (
(Always 5 V (high)))
Using the Vibrator
Vibrator is the function to vibrate the transceiver when the transceiver receives an individual call with Optional Signaling,
FleetSync/ NXDN Status Message or Short Message. With this function, a user can recognize that the transceiver is
receiving a call even in noisy environments or an environment requiring silence.
Vibrator is activated under the following conditions.
FUNC (K)/Ver 4.00
Table 22-1 Available Functions to be Assigned to Pin 11
for operations in Menu Mode.
See
Description
FPRG 8.29.6 Universal Connector Pin Number 11)
See FPRG 8.29.8 Output Control by SSW
CONTENTS INDEX 479