Installation - Toshiba AW-G9930S Service Manual

Adjust the legs so that the machine does not move.
1. After adjustment, lock the nuts of the legs by rotating them in the direction of the arrow (B)
Make sure so that the bottom of the main body front does not reach the floor.
If the bottom is in touch with the floor, then it will be the cause of shaking and abnormal noise.
Check the position of the air bubble in the floor level indicator.
2. If the bubble is not positioned inside the circle, adjust height by rotating the leg caps.
Depending on locations of the bubble in the horizontal level indicator, place caps and lock legs
(Make sure to fix adjustable legs.)
3. Mount the caps on the right-hand legs. Rotate the height adjust legs to perform height adjustments.
Hold down the diagonal line of the washing machine, and make sure that no wobbling occurs.
4. Despite the fact that the bubble is inside the circle, if the wobbling exists. Then shaking motion becomes
larger or some abnormal noise comes out. Make sure to readjust in case the washing machine wobbles.
NOTE: The machine comes with four leg caps: two for adjustment in steps of 3 mm, and two for adjustment in
steps of 6 mm. Use them in combination as required. If they are to be stacked, position the thicker
caps under thinner ones.
All manuals and user guides at all-guides.com

5. INSTALLATION

Tighten nuts of adjustable
legs, and lock them.
(EX) The washing machine is tilted towards the right
– 8 –
Unlock
Up
Height adjust leg
Note: Check the floor level
Indicator directly from above.
Circle
Bubble
Ratting
Ratting
Ratting
.
Lock
Down