Setup; Removing And Installing The Brackets - NEC Built-In AIT User Manual

Setup

The procedure up to installation of the Built-In AIT to the "basic processing unit" is explained in
the following.

Removing and installing the brackets

When you want to use the Built-In AIT as a 3.5-in device, you need to remove the left and right
brackets.
To remove the brackets
Using a Phillips screwdriver, remove the screws, and then the brackets.
Important
• Make sure that you store the brackets and screws in a safe place.
• Only use these screws when installing the brackets. They are metric
screws (length: 5.0 mm; length below washer: 4.0 mm). Using longer
screws could result in damage.
20 Built-in AIT
4.0 mm
metric screw