Advertisement
HP 11757B
Measurement
Printing Results
ignored for Static M-Curve measurements. Press
to move to the next feature.
10. The display should then read \
This feature increases measurement resolution near
the edges of the measurement, but will only be
activated if you have speci ed at least 15 data points
(we speci ed just 11 earlier in this example). Use
the
key to move to the next feature.
495
11. The display will now read \
This algorithm will initiate worst case searches
during the measurement. For a full description see
MK SEARCH in the Local and Remote Reference
Manual. Since this feature can increase measurement
time press
4 ENTER 5
then press
4 ENTER 5
12. The display will now read \
allows selection of the type of DFM calculation
performed. For a full description see MEAS in the
Local Reference. The measurement setup is now
complete. DFM TYPE is only available in serial
pre xes 3215A and above.
You are now ready to make the actual measurement.
Press
. The display will indicate that the
4 MEAS 5
measurement is in progress. When the measurement
has nished, the display will return to normal. If you
press the
4 PRESET/LOCAL 5
during the measurement, the measurement will be
interrupted and stop.
1. After the measurement has been completed, you can
print the results. First, set the printer destination.
Press
4 SHIFT 5 4 MEAS 5
arrow key to select between
Press
on
4 ENTER 5
1 DEST
Use
to select between
485
Digital Radio Testing
10 EDGE ZOOM
11 MK SEARCH
to ensure that it is set to OFF,
again.
12 DFM TYPE
key on the Fader front panel
(PRINTER), then use the
and
1 DEST
2 PRINT
to set the destination.
and
EXTERN
INTERN
495
".
".
". This
485
.
.
1-9
Advertisement
