Table of Contents
Advertisement
PRODUCT ASSEMBLY (CONTINUED)
ASSEMBLING THE FOOD GRINDER ATTACHMENT
1.
Insert the Grind Screw into the Main Housing securely. Place the Blade over the end of the
Grind Screw.
The Blade should fit entirely inside the housing. If it doesn't, pull it off, turn it over, and
place it again.
2.
Place the desired Grinding Plate over the Blade, matching the notch of the plate with the
tab on the bottom of the Main Housing.
Place the Collar on the Main Housing, turning clockwise by hand until secured but not
tightened.
ASSEMBLING THE SAUSAGE STUFFER ATTACHMENT
1.
Insert the Grind Screw into the Main Housing. Then insert the Sausage Stuffer Plate over
the end of the Grind Screw, matching the notch of the plate with the tab on the bottom of
the Main Housing.
2.
Insert the desired Sausage Stuffer Tube (large or small) through the Collar. Then, place
the Collar and tube assembly on the Main Housing, turning the ring by hand until secured
but not tightened.
ASSEMBLING THE ATTACHMENT TO THE STAND MIXER
1.
Turn the Stand Mixer OFF (0) and unplug.
2.
For Stand Mixers with a hinged power hub cover: Flip up to open.
For Stand Mixers with a removable power hub cover: Turn the attachment knob
counterclockwise to remove power hub cover.
3.
Remove the Stand Mixer Attachment Hub cover.
4.
Insert the attachment shaft housing into the Attachment Hub.
5.
Tighten the Stand Mixer Attachment Hub knob until the attachment is completely secured
to the Stand Mixer.
A
A. Sharp Side
5
Advertisement
Table of Contents
