Table of Contents
Advertisement
aus
Interrupting the programme
– Open the door.
– Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave the
door ajar for several minutes and then
close. Otherwise, expansion (pressure)
may cause the appliance door to
spring open or water to run out of the
appliance.
– To continue the programme, switch on
the ON/OFF switch ( again.
– Close the door.
Terminating the programme
T e r m i n a t i n g t h e p r o g r am m e
(Reset)
– Open the door.
– Press START button h for
approx. 3 sec. until all displays go out.
– Close the door.
The remaining programme sequence
for draining the residual water takes
approx. 1 minute.
Changing the programme
When the START button h has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme (Reset).
16
Intensive drying
The final rinse uses a higher temperature
which improves the drying result. The
running time may increase slightly.
(Caution if utensils are delicate!)
– Open the door.
– Switch on ON/OFF switch (.
– Hold down button > P and press
START button h until the setting
light )* and "Check water supply"
display )2 flash.
– Release buttons.
The displays )* and )2 flash.
To change the setting:
– Press button < H until the
display # is lit (Intensive drying on).
– Press START button h.
The displays go out. The setting is
saved.
– Close the door.
Advertisement
Table of Contents
