Toshiba B-8204-QM-R Installation Manual page 10

13) Raise the print head block until it stops.
Stopper
14) Remove the two SMW-4x8 screws that secure the strip sensors (TR) and (LED).
15) Release the strip sensor (LED) harness from the cable clamp, and disconnect it from the shorter harness
of the strip sensor harness (TR).
Strip Sensor (Tr)
Shorter Harness of the Strip
Sensor Harness (for Tr)
SMW-4x8B Screw
Strip Sensor Harness
(for LED)
- 10 -
Get other manuals https://www.bkmanuals.com
Print Head Block
SMW-4x8B Screw
Strip Sensor (LED)
Cable Clamp