Toshiba LF620 Instruction Manual page 44

○ Pulse output setting mode
This mode is used to perform continuous parameter settings (automatic operation) regarding
pulse outputs. When these parameters are set, pulse output is ready to send out.
MENU SEL
BASIC
DETAILED
PREVIEW
PLS SET
ZERO ADJ
PLS SET
(L)
ESC
▼
* (L) indicates that you can hold
down the switch longer.
(1) Digital Output 1 selection screen
The function for Digital Output 1 can be selected.
This screen shows functions related to pulse outputs only.
(For details of setting procedure, see 8.1.18.)
• PLS OUT (Pulse output)
• PLS FRD (Forward direction pulse output)
• PLS REV (Reverse direction pulse output)
(2) Count rate setting screen
Count rate can be set.
(For details of setting procedure, see 8.1.20.)
(3) Pulse width setting screen
When pulse width setting mode is MANUAL, the screen moves to Pulse width setting screen.
When pulse width setting mode is AUTO, the screen moves to Totalizer control screen.
(For details of setting procedure, set See 8.1.20.)
Note: Pulse width setting mode is set to AUTO when shipped from the factory.
(4) Counter control screen
This screen is used to start the totalizer.
If
setting mode)
(For details of operation procedure, see Section 10.2.)
Note: If
DO1 FUNC
PLS OUT
(L) (L)
▼ ▲
To Measurement mode
is pushed, the screen returns to the measurement screen. (End of pulse output
ESC
is pushed to return to the measurement screen while automatic screen
ESC
sequence in progress, the setting items entered so far are saved.
CNT RATE
0.00000
3
m
(L) (L)
▲
PLS MODE
=AUTO
− 43 −
6 F 8 A 0 9 2 7
PLS WID
PLS MODE
000.0
=MANUAL
MANUAL ms
(L) (L)
▲
CNT CTRL
12345678
ESC
FRD
■ ESC CLR