Starting The Softeners: Hot Water Part - Electrolux KITWSRT Use And Installation Manual

USE AND INSTALLATION MANUAL

2.2.2. STARTING THE SOFTENERS: HOT WATER PART

Starting the softener
•
Slowly open the inlet valve.
•
Turn knob A to the backwash position (red light on) and let it flow for a few minutes or until the system
feeds water without any air to the drain.
•
Gradually open the inlet valve until it is fully open.
•
Continue the manual regeneration, turning the valve to the "brine extraction and slow wash position" to
extract the water from the brine tank until the air check is blocked; the water level will be more or less
halfway on the air check.
•
Turn the valve to the tank filling position and let it turn automatically to the service position.
•
After starting the softener for a few minutes, run the water hardness test on the output water to check that
the water is being treated according to the requirements.
The system is ready and in service.
23