ADJUSTING THE FEED OVERLOAD
This machine is equipped with a safety overload which can be adjusted by the set
screw (Part # 73) located in the center of cover (Part # 75) which is located in the
center of the apron. (To increase tension turn clockwise, to reduce tension turn
counterclockwise). (Figure 13)
ADJUSTING HALFNUTS
1.
Remove chasing dial assembly
2.
Loosen 3 screws
3.
Adjust half nuts and re-tighten the 3 screws
4.
Test movement before reassembling.
(Figure 17)
Notes:
38