Figure 192. Installing the Access Module
2. Press in on the Access Module latches to lock them into place.
Figure 193. Locking the Access Module into place
3. Connect the cables to the Access Module.
Verify the operation of a replacement Access Module
Steps
1. From PowerStore Manager, select Hardware.
2. Select the appliance where you replaced the Access Module.
3. On the Components card, under Rear View, expand ExpansionEnclosure.
4. Select the relevant Access Module.
The status of the replacement Access Module should read Healthy. If the status is still Faulted, wait a few minutes and
refresh PowerStore Manager. If the status does not change, ensure that the Access Module is correctly seated, or contact
your service provider.
162
NVMe expansion enclosure service procedures