Installing/Removing Power Modules - Siemens RUGGEDCOM RX1500 Installation Manual

RUGGEDCOM RX1500
Installation Guide
1
2
3
Figure 16: Installing a Module
1. Module 2. Chassis 3. Screw
5. Tighten the screws to secure the module.
6. [Optional] If necessary, install the device in the rack.
7. Connect power to the device.
Section 3.3

Installing/Removing Power Modules

The RUGGEDCOM RX1500 supports dual redundant power supply modules.
Figure 17: Power Modules
1. Slot PS1 2. Slot PS2
CAUTION!
Contamination hazard – risk of equipment damage. Prevent the ingress of water, dirts and other debris
that may lead to premature equipment failure. Always make sure slots are not left empty.
NOTE
Power modules are hot swappable. When installing/removing a power module, it is not necessary to
turn off power to the redundant power module.
Installing/Removing Power Modules
1
Chapter 3
Modules
2
29