Canon Inner Finisher-J1 Service Manual page 93

5. Install the Wire Sub Tray. 6. Install the Inner Finisher to the host machine as
shown in the figure carefully so that the host
machine can not be damaged.
• 1 Pin
CAUTION:
When Installing the Inner Finisher to the host machine,
be careful of the following points.
• Do not slide the Inner Finisher on the inner part of
the host machine nor bump the Inner Finisher to
the covers of the host machine. Doing those may
cause damage to the exterior of the host machine.
• Do not bump the Inner Finisher to Sensor Flag.
• Do not to nip the Harness of the Inner Finisher
between Inner Finisher and host machine.
CAUTION:
If this equipment has to be removed from the host
machine, refer to the "Detach This Equipment from the
Host Machine" procedure.
87
6. Installation