Panasonic KX-TD500 User Manual page 183

[To CO / TIE Line]
• Class of Service
Class of Service programming determines the extension that can perform this feature
<Section 2.4 Class of Service (COS), "Call FWD to CO / TIE" in the Programming Guide>.
• Treatment of the forwarded call
Toll Restriction, Automatic Route Selection (ARS) and Account Code Entry requirements
of the extension in Call Forwarding mode still apply to the call forwarded by this feature.
• If you are storing an account code, enter the account code and then the delimiter "99" before
the line access code.
• Extension-to-CO Line Call
If a call between an extension and an outside party is established by this feature, the call
duration can be restricted by System Programming <Section 2.5 System Timer, "Extension-
to-CO Line Call Duration Time" in the Programming Guide>. This restriction applies to the
extension whose "Time Limit of Outside Calls" setting (Class of Service programming) is
set to "Yes" by System Programming.
• CO-to-CO Line Call
If a call between two outside parties is established by this feature, the call duration is
determined by System Programming <Section 2.5 System Timer, "CO-to-CO Line Call
Duration Time" in the Programming Guide>.
An alarm tone is sent to both outside parties 15 seconds before the time-out.
The call is disconnected at the time-out.
• Trunk-to-Trunk Connection
Before utilizing this feature, "Trunk to Trunk Restriction" should be enabled by System
Programming.
• You can store the telephone number up to 24 digits. Valid digits are "0 through 9," " " and
PAUSE. PAUSE can also be stored by dialing "
[No Answer - To CO / TIE Line]
• The number of rings before the call is forwarded is programmable <Section 2.5 System
Timer / Section 4.3 Extension Line, "Call Forwarding-No Answer Time" in the
Programming Guide>. If "0" is specified in Section 4.3 Extension Line, "Call Forwarding-
No Answer Time" setting in Section 2.5 System Timer works.
• Class of Service (COS) programming
COS programming <Section 2.4 Class of Service (COS), "Call FWD to CO / TIE" in the
Programming Guide> determines the extension that can perform this feature.
• Treatment of the forwarded call
Toll Restriction, Automatic Route Selection (ARS) and Account Code Entry requirements
of the extension in Call Forwarding mode still apply to the call forwarded by this feature.
• If you are storing an account code, enter the account code and then the delimiter "99" before
the line access code.
• Extension-to-CO Line Call
If a call between an extension and an outside party is established by this feature, the call
duration can be restricted depending on the setting of the system timer <Section 2.5 System
Timer, "Extension-to-CO Line Call Duration Time" in the Programming Guide>.
User Manual
Station Features and Operation (PT/SLT)
."
183