Panasonic PAN9420 Quick Start Manual page 16


Default configuration for UART0 and UART1:

Baud rate:

Data bits:

Parity bit:

Stop bits:
If successfully connected, try to send the command get system firmware using your
Terminal Program of choice, to request the firmware version of the module.
If you did not use HTerm before, please note:
If you are new to HTerm, please do not use the ASend button.
To invoke a command in Hterm –
Quick Start Guide Rev. 1.0
115200
8
none
1
UART0 does not utilize any flow control.
UART1 utilizes HW flow control (RTS/CTS). To achieve maximal throughput,
flow control for UART1 is required.
A command MUST BE followed by CR (Carriage Return) and LF (Line Feed)
as described in the communication specification. You can set your terminal to
issue them automatically.
You might also need to set the terminal's echo.

Type it in

Press [Enter] on your keyboard
Figure 8: Invoking a command in HTerm
PAN9420 Quick Start Guide
Page 16