Bosch AUTODOME 7100i User Manual page 12

12 en | Operation via the browser
Recording live video
Video sequences from the displayed live video stream can be saved locally on the computer's
hard drive. The sequences are recorded at the resolution specified in the encoder
configuration. The storage location depends on the configuration of the camera.
1.
2.
Audio Communication
Audio can be sent and received via the Live page if the device and the computer support
audio.
1.
2.
All connected users receive audio signals sent from the device but only the user who first
pressed the F12 key can send audio signals; others must wait for the first user to release the
key.
Storage, CPU and network status
When accessing the unit with a browser, the local storage , processor, WLAN, and network
status icons
When a local storage card is available, the memory card icon changes color (green, orange or
red) to indicate the local storage activity. If you hover over this icon with the mouse the
storage activity is shown as a percentage.
If you hover over the processor icon, the CPU load is shown.
If you hover over the WLAN icon, the WLAN status is shown.
If you hover over the right-hand icon, the network load is shown.
This information can help with problem solving or when fine tuning the device. For example:
–
–
–
Status icons
Various overlays in the video image provide important status information. The overlays provide
the following information:
The frame might show artifacts due to decoding errors.
Indicates that an alarm has occurred.
A communication error, such as a connection failure to the storage medium, a protocol
violation or a timeout, is indicated by this icon.
2022-12 | V01 | DOC
Click the recording icon
– Saving begins immediately. The red dot on the icon indicates that a local recording is
in progress.
Click the recording icon again to stop the local recording.
Press and hold the F12 key on the keyboard to send an audio signal to the unit.
Release the key to stop sending audio.
If the storage activity is too high, change the recording profile.
If the CPU load is too big, change the VCA settings.
If the network load is too big, change the encoder profile to reduce bitrate.
Decoding error
Alarm flag
Communication error
to record video sequences locally.
are shown in the upper right of the window.
User Manual
AUTODOME 7100i
Bosch Security Systems B.V.