5.4
Installing or Replacing Components in the GR2000-BH
The GR2000-BH allows you to add or replace not only NIFs, but also the BCU, and
power supply units. This section describes how to install or remove or replace these
components.
DANGER:
Caution:
!
Caution:
!
5.4.1
Network Interface Boards (GR2000-BH)
See the cautions at the beginning of this section.
5.4.1.1
Removing a Network Interface Board
Step 1.
Loosen the screws of a network interface board.
Step 2.
Hold both handles with your fingers and pull the network interface board
towards you.
Handles
Figure 5-4 Removing a Network Interface Board (GR2000-BH)
GR2K-GA-0007
Rev. 5.00
Switch off the unit when you install or replace power supply unit. If your
GR2000-BH has dual power supplies, you must POWER OFF BOTH POWER
SUPPLIES before you may consider power to be removed from the device.
Always power OFF the GR2000-B when you install or replace a network
interface board, or any other system component, such as a memory card.
To prevent static discharge, do not touch the components or soldered
surfaces of a network interface board. Similarly, always keep network
interface boards in their special anti-static bags when not in use.
Adding and Replacing Options
Network Interface
Board
5-5